Texas Instruments TMS320TCI648x Manuale Utente
www.ti.com
SRIO Registers
Table 57. SERDES Receive Channel Configuration Register n (SERDES_CFGRXn_CNTL) Field
Descriptions (continued)
Bit
Field
Value
Description
15–14
LOS
Loss of signal. Enables loss of signal detection with 2 selectable thresholds.
00b
Disabled. Loss of signal detection disabled.
01b
High threshold. Loss of signal detection threshold in the range 85 to 195mV
dfpp
.
This setting is suitable for Infiniband.
10b
Low threshold. Loss of signal detection threshold in the range 65 to 175mV
dfpp
.
This setting is suitable for PCI-E and S-ATA.
11b
Reserved
13–12
ALIGN
Symbol alignment. Enables internal or external symbol alignment.
00b
Alignment disabled. No symbol alignment will be performed while this setting is
selected, or when switching to this selection from another.
selected, or when switching to this selection from another.
01b
Comma alignment enabled. Symbol alignment will be performed whenever a
misaligned comma symbol is received.
misaligned comma symbol is received.
10b
Alignment jog. The symbol alignment will be adjusted by one bit position when this
mode is selected (that is, the ALIGN value changes from 0xb to 1xb).
mode is selected (that is, the ALIGN value changes from 0xb to 1xb).
11b
Reserved
11
Reserved
0
This read-only bit returns 0 when read.
10–8
TERM
001b
Input termination. The only valid value for this field is 001b. This value sets the
common point to 0.8 VDDT and supports AC coupled systems using CML
transmitters. The transmitter has no effect on the receiver common mode, which is
set to optimize the input sensitivity of the receiver. Common mode termination is
via a 50 pF capacitor to VSSA.
common point to 0.8 VDDT and supports AC coupled systems using CML
transmitters. The transmitter has no effect on the receiver common mode, which is
set to optimize the input sensitivity of the receiver. Common mode termination is
via a 50 pF capacitor to VSSA.
7
INVPAIR
Invert polarity. Inverts polarity of RIORXn and RIORXn.
0
Normal polarity. RIORXn is considered to be positive data and RIORXn negative.
1
Inverted polarity. RIORXn is considered to be negative data and RIORXn positive.
6–5
RATE
Operating rate. Selects full, half, or quarter rate operation.
00b
Full rate. Two data samples taken per PLL output clock cycle.
01b
Half rate. One data sample taken per PLL output clock cycle.
10b
Quarter rate. One data sample taken every two PLL output clock cycles.
11b
Reserved
4–2
BUSWIDTH
000b
Bus width. Always write 000b to this field, to indicate a 10-bit-wide parallel bus to
the clock. All other values are reserved. See
the clock. All other values are reserved. See
for an explanation of
the bus.
1
Reserved
0
Always write 0 to this reserved bit.
0
ENRX
Enable receiver
0
Disable this receiver.
1
Enable this receiver.
Table 58. EQ Bits
CFGRX[22–19]
Low Freq Gain
Zero Freq (at e
28
(min))
0000b
Maximum
–
0001b
Adaptive
Adaptive
001xb
Reserved
01xxb
Reserved
126
Serial RapidIO (SRIO)
SPRUE13A – September 2006