Omron CS1W-RPT01 Manuale Utente
38
Data Links Procedures
Section 2-1
1 to 1 Type
Note For automatic data link creation with 1:N allocation, use CX-Net in
CX-Programmer version 3.2 or higher.
Contents
Method
Nodes
Page
a. Set the data link mode
to automatic.
Use Support Soft-
ware for the PLC
including Program-
ming Console (see
note).
ware for the PLC
including Program-
ming Console (see
note).
Data link startup node
only
only
The node that is used
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
b. 1:N creation
Data link startup node
only
only
c. Set the area
d. Set the data link start
word
e. Set the number of
common send words
per master node
per master node
f.
Se the number of indi-
vidual send words per
master node
vidual send words per
master node
g. Set the number of
send words per slave
node
node
h. Set the first data link
status word
i. Set the nodes to par-
ticipate in the data
links.
links.