Nortel Networks R2MFC Manuale Utente

88 Chapter 7 Command Line Interface (CLI)

NN40010-300

SeizeOption <link><flag>

Sets seize interworking with opposite link upon detecting seize from far end. 

Where: 
link is the number of the link, 0 or 1.
flag is either 0 (seize process is autonomic) or 1 (seize process is 

dependant).

Autonomic - link responds to seize without waiting for opposite link ack.
Dependant - link waits for opposite link ack before sending its ack.

SzAckOpt <link><flag>

Work with seize ack or not.

Where:
link is the number of the link, 0 or 1.
flag is either 0 (seize ack is not used) or 1 (seize ack is used).

SearchMode <link><mode>

Sets MFC channel allocation mode.

Where:
link is the number of the link, 0 or 1 (applicable to link 0 only).
mode is either 0(round robin), 1 (linear ascending), or 2 (linear descending)

Round robin (default) - start search for next available channel after last 

channel used.
linear ascending - search for next available channel from channel 1 up.
linear descending - search for next available channel from 30 down.

New defined mode is effective immediately after it is defined. It must be 

saved, by using the SaveCfg command, to remain in effect after a restart. 

The new mode is saved on the EEPROM, and is always in effect, regardless 

of the Config DIP switch settings (mode is not part of the country code 

configuration).

Table 26   R2 directory CLI commands (Sheet 2 of 2)