Nortel Networks Option 11C Mini Manuale Utente
Page 322 of 332
Appendix B – Changing preprogrammed data
553-3021-209
Standard 3.00
April 2000
Conflicts with Call Park extension numbers
Extension numbers for system call park are preprogrammed for the Central
Answering Position. To remove this data from the system, load LD 50 and
respond to the prompts as follows:
Answering Position. To remove this data from the system, load LD 50 and
respond to the prompts as follows:
LD 50
REQ
OUT
TYPE
CPK
CUST
0
SPDN XXXX “XXXX” = Value of Call Park extension
Repeat for each Call Park extension you want to remove.
Conflicts with SDI ports
Five SDI/ESDI ports are preprogrammed on the Option 11C Mini system.
Ports 8 and 9 are associated with the Meridian Mail Mini. Ports 0, 1 and 2 are
associated with the NTDK97 MSC card. You cannot remove port 0; however,
you can remove any of the remaining ports using LD 17 as follows:
Ports 8 and 9 are associated with the Meridian Mail Mini. Ports 0, 1 and 2 are
associated with the NTDK97 MSC card. You cannot remove port 0; however,
you can remove any of the remaining ports using LD 17 as follows:
LD 17
REQ
CHG
TYPE
CFN
ADAN OUT TTY X “X” = the TTY that you are removing.
Conflicts with the SPRE code
If the preprogrammed SPRE code conflicts with the programming required
for the Option 11 system, use LD 15 to remove it. For customer 0 enter the
following in response to the SPRE prompt:
for the Option 11 system, use LD 15 to remove it. For customer 0 enter the
following in response to the SPRE prompt:
LD 15
SPRE Xy “y” = the value of the SPRE code
Note: To define a new SPRE code, type a space and enter the new
number.
number.