Nortel Networks 4050 Manuale Utente
Chapter 10 Configuring system settings 467
Nortel Secure Network Access Switch 4050 User Guide
port
Accesses the Host Port menu, in order to configure
port properties (see
port properties (see
).
ports
Lists the physical ports on the device, by port number.
Ports that can exist on the same network (for failover or
trunking) are listed together, separated by a comma (,).
A port that cannot exist on the same network as other
listed ports appears after a colon (:). For example:
Ports that can exist on the same network (for failover or
trunking) are listed together, separated by a comma (,).
A port that cannot exist on the same network as other
listed ports appears after a colon (:). For example:
Ports = 1,2:3
hwplatform
Displays the hardware platform of the Nortel
SNAS 4050 device.
SNAS 4050 device.
halt
Stops Nortel SNAS 4050 processing. Always use this
command before turning off the device.
command before turning off the device.
If the Nortel SNAS 4050 you want to halt has become
isolated from the cluster, you will receive an error
message when executing the
isolated from the cluster, you will receive an error
message when executing the
halt
command. In this
case, log on to the Nortel SNAS 4050 using a console
connection or remotely by connecting to the Nortel
SNAS 4050 RIP (host address). Then use the
connection or remotely by connecting to the Nortel
SNAS 4050 RIP (host address). Then use the
/boot/halt
/cfg/sys/host <host ID>
followed by: