Raritan Computer EMX2-111 Manuale Utente
Chapter 10: Using the Command Line Interface
241
d. Press Enter.
Tip: To remove an existing CA certificate, simply press Enter without
typing or pasting anything when the system prompts you to input the
certificate contents.
typing or pasting anything when the system prompts you to input the
certificate contents.
3. If the certificate is valid, the system shows the command prompt
"config:#" again. If not, it shows a message indicating that the
certificate is not valid.
certificate is not valid.
Example
This section provides a CA certificate example only. Your CA certificate
contents should be different from the contents displayed in this example.
contents should be different from the contents displayed in this example.
To provide a CA certificate:
1. Make sure you have entered the configuration mode. See
Entering
the Configuration Mode
(on page 231).
2. Type the following command and press Enter.
config:#
network wireless eapCACertificate
3. The system prompts you to enter the contents of the CA certificate.
4. Open a CA certificate using a text editor. You should see certificate
contents similar to the following.
5. Select and copy the contents, excluding the starting line containing
"BEGIN CERTIFICATE" and the ending line containing "END
CERTIFICATE" as illustrated below.
CERTIFICATE" as illustrated below.