Wayne-Dalton WDUSB-10R Manuale Utente

27

over time, you may notice the software 

response slowing down or there may be 

communication failures in your 

Z-Wave

®

 network indicated by the red 

circle slash.  This condition may be 

caused by one or more reasons such as 

Z-Wave

®

 modules with burned out light 

bulbs, weak antenna strength, missing 

or broken modules, or modules which 

have been moved in the network.  To 

optimize and repair the communication 

paths in your network, switch to the 

SeTTINGS tab and click the oPTIMIZe 

AND RePAIR NeTWoRk link.

NoTe: With some versions of Z-Wave

®

 

firmware, this link will not be available 
unless the USB Z-Wave

®

 Adapter is 

acting as Primary controller.  If this link 
is not available, try to repair the network 
using your Primary controller and then 
update the USB Z-Wave

®

  Adapter using 

the ReCeIVe UPDATe FRoM PRIMARY 
CoNTRoLLeR feature.

on Settings tab, select oPTIMIZe AND RePAIR NeTWoRk.

Thinkessentials

®

 will query every 

Z-Wave

®

 device in your network 

at a specific time interval in order  

to update the Z-Wave

®

 modules’ 

icons on the Thinkessentials

®

 user 

interface with their latest states.  

By default, the polling interval is 5 

minutes.  

1.  To change the polling interval to 

be more or less frequently, switch to 

the SeTTINGS tab and click CHANGe 

PoLLING INTeRVAL.

2.  Use the slider bar to adjust to the 

desired interval.

               Use slider bar to set desired interval. 









on Settings tab, select CHANGe PoLLING INTeRVAL.