RAD Data comm IPmux-1E Manuale Utente
IPmux-1/1E Installation and Operation Manual
Chapter 3 Operation
Operating Instructions
3-5
6. Press <Esc> to open the configuration software.
7. Enter your User Name according to your assigned system privileges (either
7. Enter your User Name according to your assigned system privileges (either
Supervisor (su) or User and then your Password when prompted (the
factory-set password is xxxxxxxxxx).
factory-set password is xxxxxxxxxx).
The Main Menu is displayed (Figure 3-8).
If the password is invalid in three consecutive attempts, the system becomes
inaccessible for 15 minutes.
Login
User Name and Password
➤
To enter as a superuser:
1. Enter su for User Name.
2. Enter xxxxxxxxxx for Password.
This allows you to configure all the parameters of Ipmux-1/1E, and to change the
su and user passwords.
1. Enter su for User Name.
2. Enter xxxxxxxxxx for Password.
This allows you to configure all the parameters of Ipmux-1/1E, and to change the
su and user passwords.
➤
To view the unit’s comfiguration:
1. Enter user for User Name.
2. Enter xxxxxxxxxx for Password.
This does not allow you to make configuration changes.
1. Enter user for User Name.
2. Enter xxxxxxxxxx for Password.
This does not allow you to make configuration changes.
➤
To set all passwords to the default value (xxxxxxxxxx
):
• Delete the unit’s configuration through the Configuration screens.
Deleting the unit’s configuration using <Cntl+A> and choosing 4 in the Boot
Menu does not set the password to the default value.
➤
If you forget your password:
• Consult Technical Support at RAD for further assistance (send email to
• Consult Technical Support at RAD for further assistance (send email to
support@rad.co.il).
Turning IPmux-1/1E Off
➤
To power off the unit:
• Switch PWR to OFF.
• Switch PWR to OFF.
Note
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com