Yamaha AW4416 Manuale Utente

Chapter7—Punch-in/out

Here’s how to perform manual punch-in/out.

❒ Make input monitor settings

For the track on which you wish to punch-in/out, you will need to monitor the 
track playback up to the punch-in point, and then monitor the input signal of the 
track (the recording source) after you punch-in. To do this, set the input monitor 
setting to “auto input monitor,” as explained below.

1. Press the [TRACK] key → [F1] key.

2. In the INPUT MONITOR area, move the cursor to the AUTO button and 

press the [ENTER] key.

The AUTO button will be turned on, and Auto Input Monitor will be selected as 
the input monitor setting.

❒ Connect a foot switch

If you will be using a separately sold foot switch (Yamaha FC-5) to perform man-
ual punch-in/out, connect the foot switch to the FOOT SW jack on the rear panel.