Yamaha AW4416 Manuale Utente

MIDI screen

Make various settings for synchro-
nization operation.

• [MIDI] key → [F2] (MIDI Sync) 

key

• Repeatedly press the [MIDI] key 

until the screen shown at the 
right appears.

M button → MIDI button → MIDI 
Sync tab

A

Select one of the following synchronization sig-
nals for output.

● OFF
Synchronization signals will not be output.

● MTC
MIDI Time Code will be transmitted from the 
MTC OUT connector.

● MIDI CLOCK
MIDI Clock will be transmitted from the MIDI 
OUT connector or TO HOST connector.

● MTC + MIDI CLK
Both MIDI Time Code (MTC OUT connector) 
and MIDI Clock (MIDI OUT connector or TO 
HOST connector) will be transmitted.

When using the AW4416 as the MIDI Clock 
master, you must set MIDI OUT SEL. to 
“MIDI OUT” in the MIDI screen MIDI Setup 
page. (→ P.39)

B

Specify whether the AW4416 will be the MTC 
master (MASTER) or slave (SLAVE) when MTC is 
used to synchronize an AW4416 song with the 
operation of an external MIDI device.

If master is selected, MTC messages will be 
transmitted from the MTC OUT connector in 
synchronization with the progress of the song. If 
slave is selected, the AW4416 song will follow 
the MTC messages received at the MIDI IN con-
nector.

The MTC frame rate is selected in the SONG 
screen Setting page (→ P.2).

C

When using MMC for remote control between 
the AW4416 and an external MIDI device, this 
setting specifies whether the AW4416 will be 
the MMC master (MASTER) or slave (SLAVE).
If master is selected, operating the transport of 
the AW4416 will cause the corresponding 
MMC command to be transmitted from the 
MIDI OUT connector or TO HOST connector.
If slave is selected, MMC commands sent from a 
MIDI sequencer or other external device can be 
used to remotely select or de-select recording 
tracks and control transport operations on the 
AW4416.

5

6

1

2

3

4