RATOC Systems CB31U Manuale Utente

MS-DOS

57

5. How to install Windows 95/98

This section gives you information on how to make a startup flopply disk on your own when the

MKDISK.EXE does not work. With the startup floppy disk, you can access to the SCSI CD-ROM drive

connected to the CB31U and install Windows 98 from the SCSI CD-ROM drive connected to the CB31U.

Follow the steps through to make a Windows 98 startup floppy disk

   1.Edit Config.sys file in a Windows 98 startup floppy disk

     Edit config.sys file in a Windows 98 startup floppy disk as shown below.(This is an example)

       DEVICE = HIMEM.SYS /testmem:off

      DEVICE = EMM386.EXE  X = CC00-CFFF

      BUFFERS = 10

      FILES = 20

       DEVICE = CBENABLE.EXE  IRQ = A  MEM = CC00

       DEVICE = ASPCB3x.SYS  /V

       DEVICE = REXCD.SYS  /D:MSCD001 /E

 NOTE:

CBENABLE.EXE  is CardBus Enabler. Refer to CBENABLE.EXE parameter.

ASPCB3x.SYS  is ASPI Manager. Refer to ASPCB3x.SYS parameter.

REXCD.SYS  is CD-ROM driver. Refer to REXCD.SYS parameter

2.a.Copy the CBENABLE.EXE, ASPCB3x.SYS, REXCD.SYS in the [Dos] folder in the CB31U

  floppy disk for Windows98/95 to the Windows 98 startup floppy disk.

    b.Copy the EMM386.EXE and MSCDEX.EXE in your system to the Windows 98 startup floppy disk.

3.Insert the Windows98 startup floppy disk and start your PC.

   When you start your system, select Start computer with CD-ROM support.

   The SCSI CD-ROM will be assigned and you can access to the SCSI CD-ROM drive. You can install

  Windows 98 from the SCSI CD-ROM drive.