Motorola MPMC101 Manuale Utente
Installing the PCI SCSI-2 Adapter
2-5
2
4. Remove the selected expansion slotÕs backplate by removing
the mounting screw and lifting out the backplate.
5. Attach a grounding strap to your wrist or ankle, and carefully
remove the adapter from its antistatic bag.
6. Set the jumpers on the PCI Adapter as described in
Terminators -
The SCSI bus (cable) must be properly
terminated at each end of the bus. The first and last device on
the bus should be the only devices that are set to provide this
function.
the bus should be the only devices that are set to provide this
function.
Terminator Power -
The SCSI terminators require adequate
voltage to properly terminate the cable. All SCSI host
adapters on the bus should be set to supply terminator
power; and where possible, be located at the end of the bus
and serve as cable terminators.
adapters on the bus should be set to supply terminator
power; and where possible, be located at the end of the bus
and serve as cable terminators.
Figure 2-3. Single-ended PCI Adapter
PCB Jumpers
Additional Connector
on Adapter Board