Allied Telesis AT-TQ2403 Manuale Utente

212 

AT-TQ2403 - Management Software - User's Guide 

You can set a Severity of between 0 (most severe) and 7 (least severe). Setting a Severity of 7 will result 
in all persistent messages being sent to the Event Log. However, if you set a Severity of 4, only messages 

with a Severity between 0 and 4 will be sent to the Event Log. To find out the current Severity level set 

for the AP, use the following command: 

AT-TQ2403# get log severity 

7 

Suppose you only want to retrieve messages with a Severity of 5 or more, use the following CLI 
command: 

AT-TQ2403# set log severity 5 

The value specified for Depth determines the number of log entries that can be saved to NVRAM. You 

can save up to a maximum of 128 entries. To determine the current Depth setting, use the following 

command: 

AT-TQ2403# get log depth 

128 

Suppose you want to limit the Depth of the log entries saved to NVRAM to 99. Use the following CLI 
command to do this. 

AT-TQ2403# set log depth 99 

The Log is a list of system messages, such as error conditions like dropping frames. To capture Access 

Point Log messages you need access to a remote syslog server on the network. The following sections 

describe how to set up remote logging for the AP. 

1.  Prerequisites for Remote Logging 

2.  View Log Settings 

3.  Enable / Disable Log Relay Host 

4.  Specify the Relay Host 

5.  Specify the Relay Port 

6.  Review Log Settings After Configuring Log Relay Host 

To capture Log messages from the access point system, you must first set up a remote server running a 

syslog process and acting as a syslog "log relay host" on your network. (For information on how to set up 

the remote server, see “

”.) 

Then, you can use the CLI to configure the AT-TQ2403 Management Software to send its syslog 

messages to the remote server. 

To view the current log settings: