Acer AcceleRAID 352 Manuale Utente
Manual No. 775051
C-1
Appendix C
AcceleRAID 352
Error Messages
☛
Note
The firmware you are using may have these messages
turned off. However, they are listed here for your
reference.
turned off. However, they are listed here for your
reference.
Start-up Error Messages
The BIOS looks for any initialization message posted by the firmware during
the start-up sequence. If a message is found, one of the following errors
displays on screen and the installation process aborts.
the start-up sequence. If a message is found, one of the following errors
displays on screen and the installation process aborts.
AcceleRAID 352 fatal error--Memory test failed!
AcceleRAID 352 fatal error--Command interface test failed!
AcceleRAID 352 hardware error--Run Diagnostics to pinpoint
error
AcceleRAID 352 firmware checksum error--Reload firmware
Drive Check Error Messages
If the firmware finds a valid controller configuration, but it doesn't match the
SCSI drives currently installed, one or more of the following messages
display:
SCSI drives currently installed, one or more of the following messages
display:
Unidentified device found at Channel=x Target=Y
Device identified for Channel=x Target=Y found at
Channel=x' Target=Y'
SCSI device at Channel=x Target=Y not responding!’,0
If any of the above messages are displayed, the firmware will not proceed
any further in the initialization process, except to find other mismatches.
Then, the BIOS prints out the following:
any further in the initialization process, except to find other mismatches.
Then, the BIOS prints out the following:
AcceleRAID 352 Configuration Checksum error--Run
configuration utility!