Actiontec electronic 1394 Manuale Utente

Step 5

Insert the PCI card into the available PCI expansion
slot. Ensure that the card is seated properly before
securing it with the screw removed in Step 4, as
shown in the following diagram.

Note: Make sure the 
power connector 
from your system is 
long enough to 
reach the card so 
that there is no ten-
sion in the wires. If 
the spare power 
connector available 
in your system will 
not reach the card, 
use the power con-
nector provided with 
the card as an 
extension

Step 6

On  the  card  is  a  white,  4-wire  “female”  power  con-
nector. Connect this device to an unused “male” con-
nector coming from your computer’s power supply.

Step 7

Put the chassis cover back on the computer.

Step 8

Make  sure  that  all  power  switches  are  in  the  OFF
position, then reconnect the power cables to the com-
puter and its peripherals.

Step 9

Turn  on  the  computer  and  proceed  to  the  following
sections to configure the Actiontec 1394 FireWire
Card for the operating system you are using.

On the rear panel of the Actiontec 1394 FireWire Card are
jacks to connect FireWire devices. Make sure, especially when
connecting multiple devices to the 1394 FireWire Card that
your PC’s internal power has been connected to the card. See
Step 6 above for details on how to make this connection.