ADC SG-1 Manuale Utente

7-25

Example(s)

Using the no ip radius source-interface command

This command deletes the radius source-interface configuration by setting it to its default value.

Usage

Example(s)

An access list is a mechanism that filters the requests to the SG-1, by reading the source IP address and its net 
mask. This mechanism allows you to grant certain workstations access to a SG-1 for administrative purposes. The 
access list command is used to create and modify access lists.

Usage

To allow SNMP access, at the second-level command prompt type one of the following (see 

“Parameter(s)”

 below 

for details):

access-list Telnet-permit <source IP address> <cr>

access-list SNMP-permit  <source IP address> <mask> <cr>

<Loopback Interface 

number>

Loopback interface number.

1 - 200

Host(config)# ip radius source-interface Ethernet 0 \ 2

Host(config)# ip radius source-interface ATM 2 \ 1 \ 44

 The following command is used to configure the SG-1 to issue requests to the RADIUS via the 

loopback interface (the source address of the packet shall be SG-1's address).

Host(config)# ip radius source-interface loopback 1

 While assigning an undefined Interface to an application the system should ignore the command and 

indicates the reason.

Host(config)# ip radius source-interface loopback 4

Operation error

Interface is not defined

Host(config)# no ip radius source-interface