Manualsbrain.com
  1. Manuali
  2. Marche
  3. ADC
  4. SG-1
  5. Manuale Utente

ADC SG-1 Manuale Utente

Scarica
Pagina di 226
2-4
Connecting to an Ethernet Port
C
ONNECTING
 
THE
 C
RAFT
 P
ORT
 I
NTERFACE
In situations where a Rear I/O card is installed, the default craft port is on the Rear I/O card. Moving a jumper on the 
Rear I/O card is required if you wish to use the front craft port.
P
OWERING
 U
P
 
THE
 SG-1
Connect to facility power using an AC power cord and confirm proper function of the AC power supplies.
I
NSTALLING
 C
ARDS
 
AND
 B
LANK
 F
ACEPLATES
Install SG-1 cards in the appropriate slots in the SG-1 chassis as indicated below. When slots do not have cards 
installed, use blank faceplates as indicated below.
Installing Cards
Once you’ve powered up the chassis, as described in 
 you can begin to install cards in the 
SG-1 chassis.
Refer to guidelines for 
 to select the appropriate slot for a card, or refer to the 
applicable card installation manual to select the appropriate slot and for detailed information on the card.
Step
Action
1
Plug the RJ-45 connector of the Ethernet cable into the FAST E-NET port on the SG-1 chassis 
back panel.
2
Connect the other end of the cable into the Ethernet port on the PC, hub, or other Ethernet device.
!
IMPORTANT
Electrical and mechanical shock hazards are present throughout the system; be aware of this 
possibility when power is applied to the chassis. Only qualified personnel should service the 
system.
Step
Action
1
Connect the power cord from the AC power connector on the SG-1 AC chassis back panel to the facility 
power source. Turn on the power switch.
2
Verify that all cabling is securely terminated.
3
On each AC power supply, verify that the power LED lights green, indicating that the power supply is 
receiving power.
Note:
 SG-1 cards are inserted under power (hot inserted).
CAUTION
When inserting the cards, make sure the cards are properly aligned on the tracks to prevent 
equipment damage or personal injury.