ADC SG-1 Manuale Utente

7-1

This chapter describes the primary commands available at the second command level. For additional second level 
commands, refer to 

.

Use the configure terminal command at the first level prompt to switch the system to the second-level configuration 
prompt, Host(config)#. This indicates that the user is now in the second level configuration mode and has 
access to the second level commands in the configuration menu. These commands change the parameters only in 
RAM. You can save a new configuration in the flash memory by returning to the first level prompt and using the write 
memory command.

Usage

configure [<network> <ip address> <alpha numeric string]

configure [<terminal>]

Parameter(s)

[<network>]

Copies a previously saved configuration from a TFTP server to NVRAM.

[<ip address>]

The IP address of the TFTP server to which the running configuration will be written.

[<alpha numeric string>]

The filename of the running configuration to be saved.

[<terminal>]

Places the user in the second level command level.

 Some non-applicable information was removed from sample screens for ease of viewing.

 Use the help facility to view a list of the second level configuration commands and their functions by 

typing ? immediately after the second level configuration prompt.

Using the write memory command following the use of the configure parameter will overwrite the 
configuration loaded from the TFTP server.