ADC Campus-REX RS Interface Card Manuale Utente
Configuring and Monitoring through the LCD
Campus-REX RS Interface Card User Manual
4-5
V
IEWING
AND
C
ONFIGURING
A
LARMS
To determine if there is an active alarm condition:
1
Press Escape until
CAMPUS RS I/F: REX
displays.
2
Press Next three times.
ALARM CONFIG & STATUS
displays.
3
Press Enter. The LCD displays the current alarm status. There are three
indicators that can appear under
indicators that can appear under
CURRENT ALARMS
:
•
HDSL
indicates an HDSL alarm
•
LOC
indicates a local alarm
•
REM
indicates a remote alarm
If a specific indicator does not display, there is no alarm in that area of
the system.
the system.
The following sections describe how to view specific alarm information for
the HDSL, local, and remote ports, and how to configure thresholds for the
various alarms.
the HDSL, local, and remote ports, and how to configure thresholds for the
various alarms.
HDSL Alarms
This section describes how to view and configure alarms on the HDSL line.
Viewing Current Alarms
If the
CURRENT ALARMS
display indicates an HDSL alarm, you can
determine the alarm type:
1
From the
CURRENT ALARMS
display, press Next.
HDSL LINK
ALARMS CONFIG & STATUS
displays.
2
Press Enter. The current status of three alarms displays:
•
LINK
shows whether the HDSL link is on or off
•
ES
shows whether the errored seconds threshold has been exceeded
on the local unit, remote unit, or both
•
MARGIN
shows whether the margin threshold has been exceeded on
the local unit, remote unit, or both
CAD1069i5.book Page 5 Thursday, May 30, 2002 7:32 AM