Cisco Systems 7609 Manuale Utente
Chapter 3 Installing the Cisco 7609 Internet Router
Attaching the Interface Cables
3-16
Cisco 7609 Internet Router Installation Guide
OL-5079-04
Figure 3-7
Supervisor Engine Console Port Connector
Note
The accessory kit that shipped with your Cisco 7609 Internet Router contains
the necessary cable and adapters to connect a terminal or modem to the
console port.
the necessary cable and adapters to connect a terminal or modem to the
console port.
To connect a terminal to the console port using the cable and adapters provided,
perform these steps:
perform these steps:
Step 1
Place the console port mode switch in the in position (factory default).
Step 2
Connect to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE
adapter or RJ-45-to-DB-9 DTE adapter (labeled “Terminal”).
adapter or RJ-45-to-DB-9 DTE adapter (labeled “Terminal”).
Step 3
Position the cable in the cable guide (if installed). Make sure that there are no
sharp bends in the cable.
sharp bends in the cable.
Step 4
Check the terminal documentation to determine the baud rate. The baud rate of
the terminal must match the default baud rate (9600 baud) of the console port.
Set up the terminal as follows:
the terminal must match the default baud rate (9600 baud) of the console port.
Set up the terminal as follows:
•
9600 baud
•
8 data bits
•
No parity
•
2 stop bits
CONSOLE
RESET
PW
R LIGHT
ACTIVE
SYSTEM
STATUS
SUPERVISOR I
WS-X6K-SUP1
CONSOLE
PORT
MODE
PORT
MODE
48127