Cisco Systems Cisco 12816 Manuale Utente

If you did not change the configuration register setting, the next reload will revert 
to the default configuration register setting (0x0102). This setting causes the 
system to boot Cisco IOS software from a flash memory card inserted in slot 0 the 
next time you boot the router. See the 

 for additional information.

You can perform a basic configuration for your router by using one of the 
following methods:

Method 1—Using the setup facility or the setup command. 

During the initial startup of an unconfigured router, the system automatically 
runs the setup facility, which enables you to begin configuring your router 
manually. The setup facility presents a structured, interactive script that 
guides you through the process.

You can also invoke the setup facility at any time to alter previously entered 
configuration information by issuing the setup command at the privileged 
EXEC mode prompt (

Milo#

). 

This method is described in the 

.

Method 2—Using global configuration mode through the Cisco IOS 
command line user interface. 

If you prefer not to use the interactive script of the setup facility to configure 
the router, you can configure it manually in global configuration mode. This 
method requires you to enter configuration commands on a line-by-line basis 
at the console without being prompted by a configuration script. This method 
is described in the