Cisco Systems Cisco 12816 Manuale Utente
Chapter 4 System Startup and Basic Configuration
Using RP Flash Memory Cards
4-52
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Booting from Flash Memory
To boot from flash memory, the boot field in the software configuration register
(bits 3 through 0) must be set to a value between 2 and 15 (see the
(bits 3 through 0) must be set to a value between 2 and 15 (see the
Use the following command to enable booting from flash memory.
boot system flash device:filename
Where:
•
boot system flash device: is slot0:, or slot1:
•
filename is the name of the configuration file
Milo# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Milo(config)# boot system flash slot0:myfile1
Copying Image Files to or From Flash Memory
This section describes how to copy image files to the flash memory SIMM on the
route processor, or to a flash memory card in slot 0 or slot 1.
route processor, or to a flash memory card in slot 0 or slot 1.
Caution
You cannot copy a new Cisco IOS software image into the onboard flash memory
SIMM (also referred to as bootflash) while the system is running from that
onboard flash memory.
SIMM (also referred to as bootflash) while the system is running from that
onboard flash memory.