D-Link DIR-635 Manuale Utente

D-Link DIR-635 User Manual

Section 3 - Configuration

Select

PPPoE (Username/Password) from the drop-down menu.

Select

Static if your ISP assigned you the IP address, subnet mask,

gateway, and DNS server addresses. In most cases, select

Dynamic.

Enter the IP address (Static PPPoE only).

Enter your PPPoE user name.

Enter your PPPoE password and then retype the password in the next

box.

Enter the ISP Service Name (optional).

Select either

Always-on, On-Demand, or Manual.

Enter the Primary and Secondary DNS Server Addresses (Static PPPoE

only).

Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature,

enable Auto-reconnect.

Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is

the default MTU.

The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not

recommended that you change the default MAC address unless required by your ISP. You can use the

Clone Your PC’s

MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.

My Internet

Connection:

Address Mode:

IP Address:

User Name:

Password:

Service Name:

Reconnection Mode:

Maximum Idle Time:

DNS Addresses:

MTU:

MAC Address:

Internet Setup

PPPoE (DSL)

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide

you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE

software from your computer. The software is no longer needed and will not work through a router.