Compatible Systems 900i Manuale Utente

For wall mounting, follow the instructions included with the 
wall-mount bracket kit.

For thick or thin Ethernet networks, you should have installed your 
Ethernet cabling before you install the MicroRouter 900i.

If you are installing a twisted-pair connection, and the twisted-pair hub 
is already in place, you can connect the router to an active network 
without interrupting network activity.

To connect the router to a thick Ethernet network, simply plug one end 
of a transceiver cable into the DB-15 transceiver connector located on 
the back panel of the unit.  Then, plug the other end of the transceiver 
cable into the transceiver which should already be attached to the thick 
Ethernet cable.

In order to connect the router to a thin Ethernet cable, connect a 
T-connector to the BNC connector located on the rear panel of the unit.

Before connecting the router to twisted-pair cabling you need an 
unshielded twisted-pair cable that is already connected to your 
10BaseT-compatible twisted-pair hub.

To connect the router to the twisted-pair network, simply plug the 
twisted-pair cable into the RJ-45 connector on the back of the unit.

The MicroRouter 900i supports high-speed synchronous or asynchro-
nous operation over one RS-232 connector.

The MicroRouter 900i supports both PPP and Frame Relay link proto-
cols on this WAN port.

This interface can be used to connect to synchronous or asynchronous 
line communications devices at rates up to 256Kbps (sync), or 230.4 
Kbps (async). Examples include modems, leased or switched 56K 
CSU/DSUs, and ISDN terminal adapters.

v Note:  If connecting to a synchronous device such as a CSU/DSU, the