Compatible Systems OCTAL V.35 Manuale Utente
Chapter 2 - Quickstart Instructions
7
IP Protocol
Required for IP
WAN interfaces which are set for PPP operation do not generally use an IP address. They are
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
Suggested for IP
These parameters help supply information about the segment that the interface is connected to.
With this information, routing can take place.
With this information, routing can take place.
•Set IP RIP 1, IP RIP 2, OSPF (Open Shortest Path First) or BGP (Border Gateway Protocol)
•Set IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIP, and the IP Static Routing Dialog
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.
TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in
the IP WAN 0 (and/or any other port numbers you wish to configure) section. Add static
routes and a default router using the edit config IP Static command.
the IP WAN 0 (and/or any other port numbers you wish to configure) section. Add static
routes and a default router using the edit config IP Static command.
v Note: Due to the complexity of BGP, configuration parameters for BGP are not given in this
Quickstart. For help with BGP configuration parameters, and other configuration questions,
refer to the Tech Support pages on the Compatible Systems Web site at:
Quickstart. For help with BGP configuration parameters, and other configuration questions,
refer to the Tech Support pages on the Compatible Systems Web site at:
http://www.compatible.com/.
IPX Protocol
Required for IPX
WAN interfaces which are set for PPP operation do not generally use an IPX address. They are
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
AppleTalk Protocol
Required for AppleTalk
WAN interfaces which are set for PPP operation do not generally use an AppleTalk address.
They are set to act as an “unnumbered interface.” In this mode of operation, there are no
required settings.
They are set to act as an “unnumbered interface.” In this mode of operation, there are no
required settings.
DECnet Protocol
Required for DECnet
The router’s shipping configuration does not have DECnet turned on. In order to be used,
DECnet must be turned on both globally and for a particular port.
DECnet must be turned on both globally and for a particular port.
•
Set DECnet on (globally, and for a port)
•
Set DECnet area
•
Set DECnet node
CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet:
WAN Dialog Box.
WAN Dialog Box.
TB: Use configure and set the Mode keyword in the DECnet WAN 0 (and/or any other port
numbers you wish to configure) section. Use configure and set the Enabled, Area, and Node
keywords in the DECnet Global section.
numbers you wish to configure) section. Use configure and set the Enabled, Area, and Node
keywords in the DECnet Global section.
v Note: Setting DECnet on for any port with the command line also sets DECnet on globally.