Compatible Systems V.35 Manuale Utente
Chapter 2 - Quickstart Instructions
5
Suggested for IP
These parameters help supply information about the segment that the interface is connected to.
With this information, routing can take place.
With this information, routing can take place.
•
Set IP RIP 1, IP RIP 2 or OSPF (Open Shortest Path First)
•
IP static routes
CV: Use the TCP/IP Routing: Ethernet 0 Dialog Box to set RIP, and the IP Static Routing
Dialog Box (under Global/IP Static Routes) to set static routes. OSPF can only be configured
using text-based configuration.
Dialog Box (under Global/IP Static Routes) to set static routes. OSPF can only be configured
using text-based configuration.
TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword for
the IP Ethernet 0 section. Use edit config and add static routes in the IP Static section.
the IP Ethernet 0 section. Use edit config and add static routes in the IP Static section.
IPX Protocol
Required for IPX
Generally, there are no required changes from the shipping Ethernet configuration for IPX.
The Ethernet interface will autoconfigure to use the two most common IPX frame types, and
will adapt to conditions on the Ethernet.
The Ethernet interface will autoconfigure to use the two most common IPX frame types, and
will adapt to conditions on the Ethernet.
Suggested for IPX
You may want to set your own network numbers, rather than using the autoconfigured values.
You may also want to turn off unused frame types.
You may also want to turn off unused frame types.
CV: Use the IPX Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the IPX Ethernet 0 section.
AppleTalk Protocol
Required for AppleTalk
Generally, there are no required changes from the shipping Ethernet configuration for Apple-
Talk. The Ethernet interface will autoconfigure to use AppleTalk Phase 2, and will adapt to
conditions on the Ethernet.
Talk. The Ethernet interface will autoconfigure to use AppleTalk Phase 2, and will adapt to
conditions on the Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the autoconfigured values.
You may also want to use more meaningful zone names.
You may also want to use more meaningful zone names.
CV: Use the AppleTalk Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the AppleTalk Phase 2 Ethernet 0 section.
DECnet Protocol
Required for DECnet
The router’s shipping configuration does not have DECnet turned on. In order to be used,
DECnet must be turned on both globally and for a particular port.
DECnet must be turned on both globally and for a particular port.
•
Set DECnet on (globally, and for this port)
•
Set DECnet area
•
Set DECnet node
CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet:
Ethernet 0 Dialog Box.
Ethernet 0 Dialog Box.
TB: Use configure and set the Mode keyword in the DECnet Ethernet 0 section. Use
configure and set the Enabled, Area, and Node keywords in the DECnet Global section.
configure and set the Enabled, Area, and Node keywords in the DECnet Global section.
v Note: Setting DECnet on for any port with the command line also sets DECnet on globally.