Compatible Systems 5.4 Manuale Utente

Tunnel Partner: VPN Configuration Dialog Box

Once you have created a VPN port, you may access the Tunnel Partner: VPN 
Configuration Dialog Box by clicking on the port’s icon and selecting VPN 
Tunnel Partner. 

v Note:  Remember that you must set up both ends of every tunnel. Therefore, 
you must repeat this setup with the remote router.

Enter the IP address of the remote Tunnel Partner with which this VPN port 
will communicate via the tunnel. This will be an interface on the remote 
router which has been set to route IP and will also be the remote VPN port’s 
Bind To interface.

Tunnel Partner devices must know each other’s IP address in order to 
correctly address the packets destined for the far end of the tunnel. This 
device’s tunnel end must have an IP address so that the Tunnel Partner can 
address packets to it. Use the pull-down menu to select an interface on this 
device which has been set to route IP. 

v Note:  If  both Ethernet ports are being used on an IntraPort 2/2+, then the 
Bind To port must be set to Ethernet 1.

v Note:  You must enter the IP address for the interface you selected here into 
the Tunnel Partner dialog box of the Tunnel Partner routers