Compatible Systems 5.4 Manuale Utente
178
Chapter 10 - WAN Link Protocols
All control characters are preceded by a backslash character (\) which tells the
router that what follows is an escaped character and should not be literally
sent on the WAN interface.
router that what follows is an escaped character and should not be literally
sent on the WAN interface.
•
\r insert a carriage return
•
\c don’t add a carriage return to end of line – valid at end of line only
•
\x insert a hex digit (range 0 to FF)
•
\p pause for 0.3 seconds
•
\b send a break character
•
\ <space> follow the backslash with a space to insert a space; space char-
acters between send or expect commands and the first character of a line
are normally stripped
acters between send or expect commands and the first character of a line
are normally stripped
•
\t insert a tab
•
\n insert a new line
•
\q set “quiet mode” – do not log output until another \q encountered
•
\\ insert a backslash
A Note About the AT Command Set
Most asynchronous devices (e.g. modems and some terminal adapters) expect
AT commands from the router in order to dial or perform other functions.
Different modems support different subsets of AT commands. To be certain
that the AT commands you are using are correct for your modem, you must
refer to the manual that came with your modem.
AT commands from the router in order to dial or perform other functions.
Different modems support different subsets of AT commands. To be certain
that the AT commands you are using are correct for your modem, you must
refer to the manual that came with your modem.
Every AT command is preceded by “AT,” which tells the modem that the
string is destined for it. Listed below are the most common (and commonly
supported) AT commands:
string is destined for it. Listed below are the most common (and commonly
supported) AT commands:
•
ATDT -- Originate a call by dialing the number sequence which follows
this command using tones (note: use a comma in the sequence for a
delay)
this command using tones (note: use a comma in the sequence for a
delay)
v Note: An asynchronous terminal adapter does not use tones to dial ISDN
phone numbers. Use ATD to dial ISDN phone numbers.
phone numbers. Use ATD to dial ISDN phone numbers.
•
ATH0 -- Hang up (note: the final character is a zero)
•
ATM0 -- Set speaker off (note: the final character is a zero)
•
ATM1 -- Set speaker on until connect
Modems typically provide a response message depending on the success of
an attempted call:
an attempted call: