Compatible Systems 5.4 Manuale Utente

Pagina di 313
66 
Chapter 3 - IPX Routing & Bridging
The IPX RIP protocol periodically sends out update information across a link. 
These periodic update packets will cause a VPN link set for dial-on-demand 
operation to either stay up indefinitely, or to continuously dial, connect, and 
then drop the connection.
If Triggered is selected with this pull-down menu, the device will 
modify the standard IPX RIP behavior for this link to send IPX RIP 
packets only when there has been an update to its routing table informa-
tion, or when it has detected a change in the accessibility of the next hop 
router.
If Periodic is selected with this pull-down menu, the device will use the 
standard IPX RIP protocol, which sends RIP packets over the link based 
on the RIP Update Timer value set below.
RIP Update Timer
This value dictates how often the device sends out IPX RIP (Routing Infor-
mation Protocol) packets on the network segments attached to this interface. 
The RIP packets sent out on this interface contain information about networks 
for which this device is responsible. RIP packets received tell the device 
about other networks and routers. The default is 60 seconds.
SAP Update Timer
This value dictates how often the device sends out IPX SAP (Service Access 
Protocol) packets on the network segments attached to this interface. The 
SAP packets sent out on this interface contain information about services 
(such as servers, printers, etc.) for which this device is responsible. SAP 
packets received tell this device about services available on other network 
segments. The default is 60 seconds.
Block IPX Type 20 Output Packets
In order for some protocols, notably NetBIOS, to function in the NetWare 
environment, devices must propagate a certain type of broadcast packet 
throughout an IPX internetwork. IPX packet type 20 is designated to perform 
broadcast propagation for these protocols.
When an IPX device receives a type 20 packet, it rebroadcasts it out all inter-
faces, except the one on which it was received. The IPX network number of 
the originating interface is included in the rebroadcast packets.
This checkbox allows you to control the rebroadcasting of IPX type 20 
packets on this interface. This is useful for on-demand links where the link 
may be brought up as a result of propagating this type of packet.
If checked, then type 20 packets will not be propagated on this interface. 
The default is unchecked.