Lucent Technologies 9077 16S Manuale Utente

2-24

SP Switch Router Adapter Guide - 1.4 Update 2

Configuring the SP Switch Router Adapter
Step 3. Change profile settings

          

    

Set specific 

dev1

 card configuration parameters at the Card profile. The fields to set are:

–

OPTIONAL: specify ICMP throttling settings    

–

OPTIONAL: change run-time binaries      

–

OPTIONAL: change dump variables     

This is the card profile for the SP Switch Router Adapter card residing in slot 8. Media card 
type, 

dev1,

 is automatically read into the read-only 

media-type

 field. Other values shown 

are defaults. At the top level, you see config and ICMP throttling fields: 

super> read card 8

CARD/8 read

super> list card 8

card-num* = 8

media-type = dev1

debug-level = 0

hssi-frame-protocol = Frame-Relay

sonet-frame-protocol = PPP

ether-verbose = 0

ports = <{ 0{off on 10 3} {single off} {"" "" 1 sonet internal-osc+

load = { 0 < > 1 0 0 } 

dump = { 0 < > off off}

config = { 0 1 1 4 0 0 }

icmp-throttling = { 10 10 2147483647 10 10 10 }

Specify ICMP throttling    

  

  

      

You can specify ICMP throttling changes for this card in these settings. Refer to Chapter 1 in 
the GRF Configuration and Management manual for an explanation of each field, or do a 

set 

<field-name>?

 for a brief description. Default values are shown:

super> list ic

echo-reply = 10

unreachable = 10

redirect = 2147483647

TTL-timeout = 10

param-problem = 10

time-stamp-reply = 10

Change default echo reply and TTL settings with this series of commands:

super> set echo-reply = 4 

super> set TTL-timeout = 12 

super> write 

CARD/8 written

You do not have to do a write until you have finished all changes in the Card profile. However, 
you get a warning message if you try to exit a profile without saving your changes.