Lucent Technologies 6000 Manuale Utente

MAX 6000/3000 Network Configuration Guide

 7-5

This operation is transparent to the fax server, except that the modems can time out if a dial-out 
request is delayed more than 30 to 40 seconds. Following is an example with Parallel Dial set 
to the maximum value for T1:

System

Sys Config

Parallel Dial=64

Following are the IP fax parameters that enable the MAX to interact with a third-party fax 
server. (The settings shown are the defaults.)

Ethernet

Mod Config

IP Fax Options

IP Fax Enabled=No

Outgoing Port=10001

Login=””

Password=””

Incoming Port=0

All Calls Are Fax=No

DNIS #1=

DNIS #2=

DNIS #3=

DNIS #4=

Server #1=0.0.0.0

Server #2=0.0.0.0

Server #3=0.0.0.0

Server #4=0.0.0.0

Server #5=0.0.0.0

IP Fax Enabled

Enable/disable IP fax support in the MAX. It is disabled by 
default.

Outgoing Port

TCP port on which to accept outgoing fax data from a fax 
server. (Outgoing fax data is received from the Internet and 
requires a dial-out to a destination fax machine.) The default 
is 10001. 

Login
Password

Name and password used to authenticate the fax server as part 
of an outgoing fax session. When the fax server receives a fax 
from the Internet, it connects to the MAX unit and sends a 
name and password. The MAX unit compares the values to 
the Server-Login and Server-Password settings.

Incoming Port

TCP port on which the fax server listens for incoming fax 
data. (Incoming fax data is received from a fax machine 
redialer.) The default is zero.