Lucent Technologies 9076 Manuale Utente
2-6
October 22, 1999
SP Switch Router Adapter Guide - 1.4 Update 2
Configuring the SP Switch Router Adapter
Installing the PCMCIA spinning disk
Installing the PCMCIA spinning disk
Installing the PCMCIA spinning disk
Your system is shipped with a PCMCIA disk device that is required to collect the system log
files. This disk can hold up to 520MB of data.
files. This disk can hold up to 520MB of data.
You can install the disk any time after the SP Switch Router is powered on and is running.
Logging is not enabled until you install the disk and complete this configuration procedure.
Logged messages can be helpful while you are configuring media cards.
Logging is not enabled until you install the disk and complete this configuration procedure.
Logged messages can be helpful while you are configuring media cards.
The configuration is done only once to set up local logs and dumps, and is not affected by
software updates or system reboots.
software updates or system reboots.
Note that the disk is used only for storage. You cannot boot the router from an external device.
Three logs provide specific information useful for monitoring and debugging SP Switch
Router operations. If you are working with Customer Support, these are the three logs they will
need to see:
Router operations. If you are working with Customer Support, these are the three logs they will
need to see:
–
/var/log/gr.console
–
/var/log/messages
–
/var/log/gr.boot
The
/var/log
directory contains other log files that collect low-level information useful
primarily to system developers.
The procedure formats and initializes an external device (
/dev/wd2a
), temporarily mounts it
on
/mnt
, creates subdirectories and symbolic links, and creates a permanent site file for storing
the symbolic links.
Note that the iflash command can be used with a -f option that forces any data on the target
device to be overwritten. When you use iflash without -f, you are informed if there is a file
system already on the device and reminded that you must use the -f option to overwrite it.
Because of its “force” capability, use the iflash -f command with caution.
device to be overwritten. When you use iflash without -f, you are informed if there is a file
system already on the device and reminded that you must use the -f option to overwrite it.
Because of its “force” capability, use the iflash -f command with caution.
The
/var/portcards
directory only contains media card dump files. These include the
dumps from media card panics and dumps created when automatic dumping is selected via the
grreset -D command (media card dumps when it comes back up). The
grreset -D command (media card dumps when it comes back up). The
/var/crash
directory
contains dumps from BSD kernel crashes.
Managing PCMCIA slots
Two commands enable remote management of PCMCIA slots. The csconfig slot_number
command returns status while csconfig slot_number up and csconfig slot_number down mark
the specified PCMCIA slot up or down, respectively.
command returns status while csconfig slot_number up and csconfig slot_number down mark
the specified PCMCIA slot up or down, respectively.