Lucent Technologies PortMaster Manuale Utente
Basic Configuration Steps
1-4
PortMaster Configuration Guide
Basic Configuration Steps
The exact PortMaster configuration steps you follow depend upon the hardware you are
installing and your network configuration. However, the following general configuration
steps are the same for all PortMaster products:
installing and your network configuration. However, the following general configuration
steps are the same for all PortMaster products:
1.
Install the PortMaster hardware and assign an IP address and a password
as described in the installation guide shipped with your PortMaster.
as described in the installation guide shipped with your PortMaster.
Note – This guide assumes that you have completed Step 1 and does not give details on
hardware installation or IP address assignment.
hardware installation or IP address assignment.
2.
Boot the system and log in with the administrative password.
You can configure the PortMaster from a terminal attached to the console port, by
an administrative Telnet session, or by a network connection.
an administrative Telnet session, or by a network connection.
3.
If you want to use PMVision software to configure your PortMaster, install
it on a workstation anywhere on your network.
it on a workstation anywhere on your network.
See the PMVision online help for more information.
4.
Configure the global settings.
PortMaster global settings are described in Chapter 3, “Configuring Global Settings.”
5.
Configure the Ethernet settings, and configure the IP and IPX protocol
settings for your network.
settings for your network.
PortMaster Ethernet settings are described in Chapter 4, “Configuring the Ethernet
Interface.”
Interface.”
6.
Configure the asynchronous port(s).
PortMaster asynchronous port settings are described in Chapter 6, “Configuring a
Synchronous WAN Port.”
Synchronous WAN Port.”
7.
Configure the synchronous port(s), if available.
PortMaster synchronous port settings are described in Chapter 6, “Configuring a
Synchronous WAN Port.”
Synchronous WAN Port.”
8.
Configure ISDN BRI connection(s), if available.
✍