Huawei Aolynk DR811 Manuale Utente

User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router

4 Web-based Management

Figure 4-28 ZIPB setting

This page allows you to:

Enable/disable the ZIPB mode.

Perform advanced ZIPB configurations.

If the ZIPB is currently disabled, you may click the

button to enable it. If the

ZIPB is currently enabled, you may click the

button to disable it.

To select which of your LAN computers will use the public IP address, click on the

drop-down list below Choose which computer will use the public IP address,

position the cursor over the entry and left-click to select a LAN computer, and then click

the

button.

To perform advanced ZIPB configurations, proceed according to the following steps:

Select the LAN interface that ZIPB will run on: click on the LAN interface drop

down list and select an interface.

Select the WAN interface that ZIPB will run on: click on the WAN interface drop

down list and select an interface.

Once you have configured ZIPB, click the

button.

& Note:

Make ensure that ZIPB is disabled before you configure ZIPB. Edit the configurations

and click OK, the new configuration will take effect after you enable ZIPB.

Configuration changes on ZIPB will not be kept permanently, so you need to configure

it again whenever the Router is restarted. In this way, remember to renew the IP

address of the ZIPB host first.