Planet Technology ADE-3410v2 Manuale Utente
You will see the following information pertinent to the ADSL line in the page:
Mode: G.DMT/G.LITE/T1.413/ADSL 2+/ADSL 2/READSL2
Line Coding: Trallis on, etc.
Status: Link Down, No Defect, Training
Link Power State: L0, L1, L2
Rate (Kbps): Upstream Line Rate/Downstream Line Rate.
At the lower part of this interface, there is a “Reset Statistics” button. Click it to return
values to zero and recount.
Click “ADSL BER Test” to do a “Bit Error Rate” Test on the DSL line.
Mode: G.DMT/G.LITE/T1.413/ADSL 2+/ADSL 2/READSL2
Line Coding: Trallis on, etc.
Status: Link Down, No Defect, Training
Link Power State: L0, L1, L2
Rate (Kbps): Upstream Line Rate/Downstream Line Rate.
At the lower part of this interface, there is a “Reset Statistics” button. Click it to return
values to zero and recount.
Click “ADSL BER Test” to do a “Bit Error Rate” Test on the DSL line.
The Tested Time (sec) has the following choices: 1, 5, 10, 20, 60, 120, 180, 240, 300, and
360. Select a time and then click “Start”.
360. Select a time and then click “Start”.
Note: If the error ratio reaches up to “e-5”, the user will not be able to access the Internet.
3.4.7 Route
Click “Routing Table”. If the system is in the default configuration, the routing table will
be as follows:
be as follows:
23