Planet Technology ADE-3410v2 Manuale Utente
3. In the “ATM PVC Configuration” interface configure VPI/VCI as 8/35 and then
click “Next”.
4. In the “Connection Type” interface, select “PPP over Ethernet (PPPoE)” and
“LLC/SNAP-BRIDGING” as the encapsulation, and then click “Next”.
5. In the “PPP User name and Password” interface, enter the user name and password
provided by your ISP. And then click “Next”.
6. In the “Enable IGMP Multicast and WAN Service” interface, keep the default
configuration unchanged and then click “Next”.
7. Check the network configurations and make sure that all settings agree with the data
provided by your ISP, and then click “Save”.
8. Click “Save/Reboot” to apply the changes and reboot the system.
You can also modify the PVC 8/35. If you need to modify the LAN IP address and
DHCP server information, you can do it in “LAN” in “Advanced Setup”.
After the dial-up is successful, the IP address that the ROUTER obtains at the WAN-side
port ppp_8_35_1. Query “Device Info” “Route” and the route table is as follows:
DHCP server information, you can do it in “LAN” in “Advanced Setup”.
After the dial-up is successful, the IP address that the ROUTER obtains at the WAN-side
port ppp_8_35_1. Query “Device Info” “Route” and the route table is as follows:
4.3 MER+DHCP Mode
Descriptions
In this example, the ROUTER is connected to the DSLAM through PVC 8/35 and the
access mode is the MER+NAT. The downlink interface of BRAS is encapsulated in
1483B, the IP address is 10.28.108.1 and the DHCP Server is enabled, the address pool is
10.28.108.* (2~254), the IP address of the uplink interface is 10.61.92.157; the WAN IP
In this example, the ROUTER is connected to the DSLAM through PVC 8/35 and the
access mode is the MER+NAT. The downlink interface of BRAS is encapsulated in
1483B, the IP address is 10.28.108.1 and the DHCP Server is enabled, the address pool is
10.28.108.* (2~254), the IP address of the uplink interface is 10.61.92.157; the WAN IP
56