Rosewill RNWB-11001 Manuale Utente

This chapter will show you how to configure the basic functions of your RNX-N300RT using 

Quick Setup Wizard within minutes. 

The default IP address of the RNX-N300RT is 192.168.1.1. And the default Subnet Mask 

is 255.255.255.0. These values can be changed as you desire. In this guide, we use all 

the default values for description. 

Connect the local PC to the LAN ports of the Router. And then you can configure the IP 

address for your PC in the following two ways. 

¾

 

1)  Set up the TCP/IP Protocol for your PC. If you need instructions as to how to do 

this, please refer to Appendix B: "Configuring the PC". 

2)  Configure the network parameters. The default IP address is 192.168.1.xxx 

("xxx" is any number from 2 to 254), Subnet Mask is 255.255.255.0, and 

Gateway is 192.168.1.1 (The Router's default IP address) 

¾

 

1)  Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your 

PC. If you need instructions as to how to do this, please refer to Appendix B: 

2)  Then the built-in DHCP server will assign IP address for the PC. 

Now, you can run the Ping command in the command prompt to verify the network 

connection between your PC and the Router. The following example is in Windows 2000 

OS. 

Open a command prompt, and type ping 192.168.1.1, and then press Enter. 

¾

  If the result displayed is similar to the Figure 3-1, it means the connection between 

your PC and the Router has been established well.   

-16-