Rosewill EASYN400 Manuale Utente

 

109

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a 

residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications.  However, 

there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, 

the user is encouraged to try to correct the interference by one of the following measures: 

 

z 

Reorient or relocate the receiving antenna. 

z 

Increase the separation between the equipment and receiver. 

z 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

z 

Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation. 

 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could 

void the user's authority to operate this equipment. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.   

 

We declare that the product is limited in CH1~CH11 by specified firmware controlled in the USA. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

 

Requirements for indoor vs. outdoor operation, license requirements and allowed channels of operation apply in 

some countries as described below: 

. In Italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors. 

. In Belgium outdoor operation is only permitted using the 2.46 - 2.4835 GHz band: Channel 13. 

. In France outdoor operation is only permitted using the 2.4 - 2.454 GHz band: Channels 1 - 7.