Sagem 1500 Manuale Utente
2 - Description and physical installation
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Page 2-10
Page 2-10
Reproduction and communication prohibited without the written permission of
E
E
E
E
2.3.5
Attach to Your Network Using Ethernet Cabling
The four LAN ports on the SAGEM F@st
TM
1500 ADSL Router auto-negotiate the connection
speed to 10 Mbps Ethernet or 100 Mbps Fast Ethernet, as well as the transmission mode to half
duplex or full duplex. Use RJ-45 cables to connect any of the four LAN ports on the
SAGEM F@st
duplex or full duplex. Use RJ-45 cables to connect any of the four LAN ports on the
SAGEM F@st
TM
1500 ADSL Router to an Ethernet adapter on your PC. Otherwise, cascade
any of the LAN ports on the SAGEM F@st
TM
1500 ADSL Router to an Ethernet hub or switch,
and then connect your PC or other network equipment to the hub or switch. When inserting an
RJ-45 connector, be sure the tab on the connector clicks into position to ensure that it is
properly seated.
RJ-45 connector, be sure the tab on the connector clicks into position to ensure that it is
properly seated.
!
Do not plug a phone jack connector into an RJ-45 port. This may damage the
SAGEM F@st
SAGEM F@st
TM
1500 ADSL Router.
Use 100-ohm shielded or unshielded twisted-pair cable with RJ-45 connectors for
all Ethernet ports. Use Category 3, 4, or 5 for connections that operate at
10 Mbps, and Category 5 for connections that operate at 100 Mbps.
all Ethernet ports. Use Category 3, 4, or 5 for connections that operate at
10 Mbps, and Category 5 for connections that operate at 100 Mbps.
Make sure each twisted-pair cable length does not exceed 100 meters (328 feet).
2.3.6
Connect the Power Adapter
Plug the power adapter into the power socket on the rear of the SAGEM F@st
TM
1500 ADSL
Router, and the other end into a power outlet.
Check the power indicator on the front panel is lit. If the power indicator is not lit, refer to
“Troubleshooting” on Appendice A.
“Troubleshooting” on Appendice A.
In case of a power input failure, the SAGEM F@st
TM
1500 ADSL Router will automatically
restart and begin to operate once the input power is restored.