Rosewill RNX-N400LX Manuale Utente

Wireless Distribution System uses wireless media to communicate with other APs, like 

the Ethernet does. To do this, you must set these APs in the same channel and set MAC 

address of other AP that you want to communicate with in the table and then enable the 

WDS. 

 

Click the check box to enable wireless distribution system. 

Fill in the MAC address of AP to register the wireless distribution 
system access capability. 

Select the transmission data rate from pull-down menu. Data rate 
can be auto-select, 1M to 54Mbps or MCS. 

Fill in the comment tag for the registered client. 

Click the Apply Changes button to complete the new configuration 
setting. 

Click the Reset button to abort change and recover the previous 
configuration setting. 

Click button to configure wireless security like WEP(64bits), 
WEP(128bits), WPA(TKIP), WPA2(AES) or None 

It shows the TX, RX packets, rate statistics. 

Click to delete the selected clients that will be access right removed 
from this WLAN Broadband Router. 

Click to delete all the registered clients from the access allowed list. 

Click the Reset button to abort change and recover the previous 
configuration setting. 

 

Requirement: Set [Wireless]->[Basic Settings]->[Mode]->AP+WDS 

This page is used to configure the wireless security between APs. 

 

26