Roland TD-15 Manuale Utente

Troubleshooting

If you don’t hear sound, or if the system does not operate as you expect, please check the following points first.
If you are still unable to resolve the problem, contact your retailer, the nearest Roland Service Center, or an authorized Roland

distributor, as listed on the “Information” page.

Is the connection cable correctly con-

nected to the TRIGGER INPUT connector?

Check the connections.

—

Are the cables correctly connected to each

pad and pedal?

Are the cables correctly connected to the

TD’s OUTPUT jacks or the PHONES jack?

Are the cables correctly connected to the

input jacks of your amp or audio system?

Could there be a problem with the

connection cables?

Try using other cables.

—

Could the [VOLUME] knob be turned all

the way to the left?

Try raising the volume of the TD.
If you’re using the TD-15, check the side

panel [VOLUME] knob as well.

Have you made the correct input selection

setting on your amp or audio system?

Check your amp or audio system.

—

Are the volume settings of your amp or

audio system appropriate?

Try raising the volume of your amp or

audio system.

—

Check the type of USB flash drive.

Use a USB flash drive sold by Roland. We

cannot guarantee correct operation if any

other product is used.

—

Check the format of the USB flash drive.

The TD can use USB flash drives that are

formatted in FAT format.
Reformat the USB flash drive using the TD.

Does the TD support the sampling

frequency and bit rate of the MP3 file, or

the sampling frequency and bit depth of

the WAV file?

Use MP3/WAV files that the TD supports.

Playback may be unable to keep up if you raise the playback speed or change the pitch

of a high bit-rate MP3.

—

Is there sufficient free space on the USB

flash drive?

Delete unneeded files from the USB flash

drive, or use a higher-capacity USB flash

drive.

It’s not possible to set the “A” and “B” times

any closer than one second.

Make sure that there is at least one second

between the two times.

When using an MP3 file, it might not be possible to play back the A-B repeat region

correctly.

Is the TD correctly connected to your

computer?

Check the connection to your computer.

Is the USB driver installed?

You must first install the USB driver in your

computer.

Make sure that the USB cable connecting

the TD to your computer’s USB port is

compatible with USB 2.0 Hi-Speed.

Use a computer and cable that support

USB 2.0 Hi-Speed.