TP-LINK TL-WPA281 Manuale Utente
TL-WPA281/TL-WPA271
Wireless N Powerline Extender
5
WiFi/WPS Button
Ethernet Port
Pair Button
Reset Button
Item
Description
WiFi/WPS
Press the button for 2 seconds, the Extender will wait to be connected by WPS.
Pressing the button for 5 seconds will enable or disable the wireless function.
Pressing the button for 5 seconds will enable or disable the wireless function.
Ethernet
One 10/100Mbps Ethernet port connected to PC LAN card or broadband device.
Reset
Use a pin to press and hold this Reset button for approximately 10 seconds, then
the device will restore to factory defaults.
the device will restore to factory defaults.
Pair
Pair buttons are used to secure a powerline network.
)
Note:
1. If you press the Pair button for more than 10 seconds, The Extender will leave the network it is
associated with and its network name assumes a random value.
2. For detail information about the Reset button and Pair button, please refer to
2.4 Hardware Connection
Please first make sure that your PC can successfully access the Internet via the Router. Then connect
the powerline devices following the instructions below.
the powerline devices following the instructions below.
Step 1: Connecting to the Internet
This section describes how to connect the Powerline Extender into your existing network. Follow the
procedures described below:
procedures described below:
1. Connect an Ethernet (RJ45) cable to the Ethernet port of the Powerline Extender or a compatible
Powerline Adapter like TL-PA211.
2. Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your broadband
Router.
3. Plug the Powerline Extender or Powerline Adapter into a wall socket.