AT&T 585-300-903 Manuale Utente

AUDIX System Administration

13-5

_ 

______________________________________________________________________________________

_ 

______________________________________________________________________________________

_ 

______________________________________________________________________________________

•

password

Enter 5 to 10 alphanumeric characters.  This password does not have to be unique.  Record it on paper
so that it is not forgotten — you will need it when administering the other systems in the network.  The
password will not be displayed the next time you enter the form.

If you change the password and the AUDIX system is running R1V3 or R1V4 software, run the
network data audit.  To run the audit, see the

form.  If the system

is running R1V5 or later software, this step is not necessary.

This machine password is not the same password as Initialization and Administration
System (INADS).  It is used only by remote AUDIX systems to access this local system.

•

extension length

This field should already be set to the correct length, the length of the switch extensions used by the
local subscribers.

•

voice name

This field indicates the presence of a recorded machine name fragment; no assignment is required at this
time.  Instructions for recording names are given later in this chapter.

•

voice ID

This is a display-only field showing the identifier associated with this machine’s name fragment.  The
identifier is used when recording the fragment.  The local AUDIX voice ID is always 0.

•

default community

The default community of AUDIX system subscribers for this machine.  A community contains those
subscribers who are able to send voice mail messages as permitted on the

system : sending

restriction

form.  This value can be overridden for individual subscribers on the

subscriber

: local

form.

Using this field and the

system : sending restriction

form, you can permit subscribers to

send, or prevent them from receiving, digital networking messages on a community-of-interest basis.
See the AUDIX Feature Descriptions for details about the sending restrictions feature.

•

network connection type

This is the type of connection the AUDIX system will attempt to set up for the test call.

— Enter

dcp

if the system has only Digital Communications Protocol (DCP) connections to the

switch.

— Enter

rs232a

if the system has only switched RS-232 connections to the switch.  Check the option

settings on the modems or data sets for synchronous or asynchronous to be sure.  If they are set for
synchronous, enter

rs232s

.

—  If the system has DCP and RS-232 connections, enter

dcp

for now.

•

data rate