ZyXEL Communications NBG-416N Manuale Utente
Chapter 4 Modes
NBG-416N User’s Guide
39
4.2 Setting your NBG-416N to Router Mode
The NBG-416N is set to wireless router mode by default. If it was changed and
now you want to set it back, do the following procedure.
now you want to set it back, do the following procedure.
1
Connect your computer to the LAN port of the NBG-416N.
2
The default LAN IP address of the NBG-416N is 192.168.1.1 in router mode
(192.168.1.2 by default in non-router mode). In router mode, the NBG-416N can
assign your computer an IP address, so you must set your computer to get an IP
address automatically (computer factory default) or give it a fixed IP address in
the range between 192.168.1.3 and 192.168.1.254.
(192.168.1.2 by default in non-router mode). In router mode, the NBG-416N can
assign your computer an IP address, so you must set your computer to get an IP
address automatically (computer factory default) or give it a fixed IP address in
the range between 192.168.1.3 and 192.168.1.254.
3
After you’ve set your computer’s IP address, open a web browser such as Internet
Explorer and type the IP address of the NBG-416N as the web address in your web
browser.
Explorer and type the IP address of the NBG-416N as the web address in your web
browser.
4
Log into the Web Configurator. See the
how to do this.
5
Go to Maintenance > Sys OP Mode > General and select Router.
Figure 24 Maintenance > Sys OP Mode > Router
6
A pop-up window appears providing information on this mode. Click OK in the
pop-up message window. Click Apply.
pop-up message window. Click Apply.
Note: Wait while the NBG-416N restarts, then log in to the Web Configurator again.
The NBG-416N IP adress is now 192.168.1.1.