ZyXEL Communications P-793H Manuale Utente
Chapter 34 Firmware and Configuration File Maintenance
P-793H User’s Guide
330
34.4.2 Restore Using FTP Session Example
Figure 218 Restore Using FTP Session Example
to read about configurations that disallow TFTP and FTP
over WAN.
34.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter “y” at the following screen.
Figure 219 System Maintenance: Restore Configuration
2 The following screen indicates that the Xmodem download has started.
Figure 220 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Figure 221 Restore Configuration Example
4 After a successful restoration you will see the following screen. Press any key to restart
the ZyXEL Device and return to the SMT menu.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
Type the configuration file’s location,
or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.