Gefen EXT-HDKVM-LAN Manuale Utente

page | 29

1.  Access the Web interface for the Sender unit.

2.  Click the 

Functions tab.

3.  Locate the 

Serial over IP group and change the RS-232 settings to match the 

settings of the RS-232 device that is being used.  In this case, we need to use the 

settings from Table 2.1 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4.  Make sure that the 

Enable Serial over IP box is checked. 

 

 

 

 

 

5.  Click the 

Save button in the lower-right corner of the Serial over IP group.

6.  The following message will be displayed, at the top of the page, indicating that the 

new Serial over IP options have been applied.  

 

 

 

7.  Click the 

Reboot button near the bottom portion of the page to apply the changes. 

 

If the unit is not rebooted within a certain period of time, the “Reboot for new settings 

to take effect” will be displayed at the top of the page.

8.  Repeat steps 1 through 6 for the Receiver unit.

NOTE:  If Enable Serial over IP is not checked, then RS-232 

pass-through will be disabled.

Operating the HD KVM over IP

Using RS-232