Gefen EXT-HDKVM-LAN Manuale Utente
page | 43
Operating the HD KVM over IP
To reset a HD KVM over IP Sender and / or Receiver unit to factory-default settings, follow
the instructions below.
Sender Unit
1. Disconnect the power from the Sender unit.
2. Press and hold the
Mode button.
3. While continuing to press the
Mode button, reconnect the power.
4. Continue holding the
Mode button until both Power and Link indicators begin
to flash.
5. Use the end of a paper clip or other sharp pointed device to press the
Reset button.
6. After the
Power LED indicator stops flashing, the unit will be ready for use.
Receiver Unit
1. Disconnect the power from the Sender unit.
2. Press and hold the
Switch button.
3. While continuing to press the
Switch button, reconnect the power.
4. Continue holding the
Switch button until both Power and Link indicators begin
to flash.
5. Use the end of a paper clip or other sharp pointed device to press the
Reset button.
6. After the
Power LED indicator stops flashing, the unit will be ready for use.
Performing a Factory Reset