NEC IP8800/S3600 Manuale Utente
7.
Restarting the System
161
As CPU memory dump is collected in Step 2, no parameter is selected as shown in figure above.
Step3
At last, select which system is restarted or stopped.
Figure 7-3: Selecting the System to Be Restarted or Stopped
As the standby system is restarted in Step 3, select "standby" as shown in figure above. Combining parameters
selected in Step 1 to Step 3 results in "reload standby." Entering this command outputs the dump collection
confirmation message as shown below.
1. Dump information extracted?(y/n):_
2. standby :old dump file(rmdump 06/21 18:32) delete OK? (y/n): _
3. Restart OK? (y/n): _
selected in Step 1 to Step 3 results in "reload standby." Entering this command outputs the dump collection
confirmation message as shown below.
1. Dump information extracted?(y/n):_
2. standby :old dump file(rmdump 06/21 18:32) delete OK? (y/n): _
3. Restart OK? (y/n): _
The output timing of above message corresponds to each number in flow chart shown below.
Set the system to restart
or stop
Specifying the
active system
Specifying the
standby system
Specifying when
operated in duplex
or single system
Parameter to input
Active
Standby
None