Peerless Industries UST-WallArm3 Manuale Utente

ISSUED:07-25-11 SHEET #: 125-9225-1

•  Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US

customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact

your local distributor.

•  This product should only be installed by someone of good mechanical aptitude, has experience with basic building

construction, and fully understands these instructions.

•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

•  Never exceed the Maximum Load Capacity. See page one.

•  If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of

an “edge to edge” stud finder is highly recommended.

•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

•  Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

•  This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal

injury.

•  This product was designed to be installed on the following wall construction only;

 

•  Wood Stud  

Included

•  Wood Beam

Included

•  Solid Concrete

Included

•  Cinder Block

Included

•  Brick

Contact Qualified Professional

•  Other or unsure?  

Contact Qualified Professional

•  stud finder ("edge to edge" stud finder is recommended)
•  phillips screwdriver
•  drill
•  1/4" bit for concrete and cinder block wall
•  5/32" bit for wood stud wall
•  level
•  masking tape
•  6 mm allen wrench

Parts List.................................................................................................................................................................................3
Wall Plate Location Template .................................................................................................................................................4
Installation to Single Wood Stud Wall .....................................................................................................................................5
Installation to Solid Concrete and Cinder Block Wall .............................................................................................................6
Attaching adapter plate assembly to projector .......................................................................................................................7
Installation using wall arm bracket .........................................................................................................................................8
Installation using wall arm bracket and extension bracket .............................................................................................. 9-10
Adjusting the Projector ................................................................................................................................................... 12-13
Fasten wall arm cover ......................................................................................................................................................... 14