Peerless Industries PRG-UNV-S Manuale Utente

Pagina di 51
2 of 51
ISSUED: 09-30-09   SHEET #: 056-9024-5  07-18-11
NOTE: Read entire instruction sheet before you start installation and assembly. 
Table of Contents
Parts List................................................................................................................................................ 3
Projector Mount Assembly Installation................................................................................................4-7
Attaching Adapter Plate to Projector...................................................................................................... 9
Accessories ................................................................................................................................... 15, 16 
Tools Needed for Assembly
•  stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
•  5/16" bit for solid concrete surface
•  5/32" bit for wood studs
•  open end wrench
• level
•  Do not begin to install your Peerless product until you have read and understood the instructions 
and warnings contained in this Installation Sheet. If you have any questions regarding any of the 
instructions or warnings, for US customers please call Peerless customer care at 
1-800-865-2112, for all international customers, please contact your local distributor.
•  This product should only be installed by someone of good mechanical aptitude, has experience 
with basic building construction, and fully understands these instructions.
•  Make sure that the supporting surface will safely support the combined load of the equipment and 
all attached hardware and components.
•  Never exceed the Maximum UL Load Capacity. See page one.
•  If mounting to wood joists ceilings, make sure that mounting screws are anchored into the center 
of the studs. Use of an "edge to edge" stud fi nder is highly recommended.
•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•  Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly 
reducing their holding power.
•  This product is intended for indoor use only. Use of this product outdoors could lead to product 
failure and personal injury.
•  This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION   
HARDWARE REQUIRED
• Wood 
Stud 
  Included
• 
Wood 
Joist 
  Included
• 
Solid 
Concrete 
  Included
•  Brick  
 
 
Contact Qualifi ed Professional (Not Evaluated By UL)
•  Other or unsure? 
 
Contact Qualifi ed Professional
WARNING